Model BGR-2

The BGR-2 is high performance pilot operated back pressure regulator intended for applications where upstream pressure control is critical for a broad range of flow requirements. The BGR-2 was designed for use with back pressure from 15 to 300 psi (1 - 20.7 Bar). See BGR-1 for back pressures below 15 psi.

Inlet Design Pressure

• Maximum Setpoint: 300 psi (20.7 Bar)

Line Sizes

• 1" (DN25)
• 1-1/2" (DN40)
• 2" (DN50)
• 3" (DN80)
• 4" (DN100)

End Connections

• NPT female
• Flanged

Body/Cover Dome Materials of Construction

• DI
• CS
• SST

DI = Ductile iron
CS = Cast carbon steel
SST= Stainless Steel

NOTE: Remaining materials are stainless steel unless noted otherwise in Table 4.

Features

• Versatile: Specially designed for use on most industrial gasses with a broad temperature range. Multiple trim options are available for a wide variety of applications.
• Tight Shut Off: Meets ANSI/FCI 70-3 Class VI.
• Trim Design: A flow-to-open trim design allows for superior control at minimal flow conditions. The pressure balanced design also eliminates deviation due to supply pressure effects.
• Heavy-Duty Guiding: Two points of guiding allows for consistent sealing, reduced wear, and increased trim longevity.
• Failure Position: Loss of loading pressure to the cover dome will cause the valve
  to close.